Polymaker PolyLite LW-PLA

Complete technical data sheet with print conditions, material properties, and performance specifications.

Grey, 0.8kg - $32.99 Bright Yellow, 0.8kg - $32.99

Product Information

Manufacturer	Polymaker
Product Name	PolyLite LW-PLA
Filament Type	PLA
Finish	Lightweight

Print Conditions

Nozzle Temperature	190-210°C
Bed Temperature	25-60°C
Print Speed	50-100mm/s
Cooling Fan	On
Build Surface Materials	Glass PEI

Technical Properties

Diameter	1.75-2.85mm
Density	0.9g/cm³
Glass Transition Temperature	59°C	DSC
Melting Temperature	150°C	DSC
Decomposition Temperature	274°C
Heat Deflection Temperature	50-54°C
Young's Modulus (X-Y)	1688.5MPa	ISO 527
Tensile Strength (X-Y)	24.4MPa	ISO 527
Elongation at Break (X-Y)	8.8%	ISO 527

Additional Characteristics

Effect of Weak Acids	Good	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla
Effect of Oils and Grease	Good	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla
Effect of Strong Acids	Poor	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla
Effect of Strong Alkalis	Poor	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla
Foaming Technology	Enabled	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla
Surface Finish	Matte (hides layer lines)	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla
Weight Reduction	Low density (0.9 g/cm³)	https://wiki.polymaker.com/polymaker-products/more-about-our-products/documents/technical-data-sheets/pla/lw-pla

This data sheet is for quick reference only. Data is sourced from manufacturer specifications and should be verified. Always confirm specifications on the manufacturer's official website before making purchasing or design decisions. Report any issues or discrepancies using the button on the right.